Significant Expansion and New Long Gold Intersections within Endomines Korvilansuo and New Encouraging Results from Rämepuro, Eastern Finland

Significant Expansion and New Long Gold Intersections within Endomines
Korvilansuo Gold Property and New Encouraging Results from Rämepuro, Eastern
Finland
At 09.00 today a press release with the headline “Significant Expansion and New
Long Gold Intersections within Endomines Korvilansuo and New Encouraging Results
from Rämepuro, Eastern Finland” was distributed by Cision. The press release was
distributed without sufficient information in the body text, all info could be
found in the attached PDF. The mistake was caused by a manual error. Cision
accepts full responsibility and apologizes to Endomines AB and other stake
holders for this error. The full release is as follows.
Endomines is pleased to announce results of the 2012 drilling campaigns at its
Korvilansuo and Rämepuro properties located at Karelian Gold Line, Eastern
Finland. Drilling campaign at Korvilansuo aimed to increase geological
understanding and increase resources of the deposit. Drillings at Korvilansuo
property has intersected gold mineralization represented by core sections from a
couple of metres up to almost 50 metres in length with encouraging results. The
drilling at Rämepuro was aiming to provide additional information from the areas
where the information was less dense. Both campaigns succeeded well in their
goals.

KORVILANSUO
Korvilansuo is located on the Karelian Gold Line, near Ilomantsi, in Eastern
Finland and the mineral rights of the property are fully owned by the Company.
Finnish authorities have within the last weeks granted new claims for the next 5
years over the whole target area.

The 2012 core drilling campaign at Korvilansuo was aimed at extending and
verifying the gold mineralization discovered during the 2011 campaign, with a
total of 3905 m of diamond drilling completed. Previously unpublished intercepts
include:

  · 49.6 m @ 2.1 g/t gold
  · 20,5 m @ 4.6 g/t gold
  · 16.9 m @ 5.3 g/t gold
  · 14.8 m @ 4.6 g/t gold
  · 12.3 m @ 1.3 g/t gold
  ·  8.0 m @ 2.4 g/t gold
  ·  7.0 m @ 4.1 g/t gold
  ·  6.6 m @ 2.1 g/t gold
  · 6.3 m @ 3.0g/t gold
  · 6.0 m @ 1.7 g/t gold
  · 4.5 m @ 1.7 g/t gold
  · 3.3 m @ 21.3 g/t gold
  · 3.0 m @ 5.9 g/t gold
  · 3.0 m @ 3.6 g/t gold
  · 2.7 m @ 10.0 g/t gold
  · 2.0 m @ 6.8 g/t gold

“The exploration program in the Korvilansuo-Muurinsuo area is just beginning but
all of the results so far obtained support our firm conviction that this area
has all the necessary characteristics of Archean greenstone-hosted gold
provinces and real potential for growing into a significant and successful gold
project”, comments Endomines CEO Markus Ekberg.

Additional 320 more assays are still pending and should be received within the
next few weeks. Full exploration results for the Korvilansuo property are
tabulated in the appendix.

Korvilansuo, along the Karelian Gold Line in Ilomantsi, is a typical Archaean
orogenic gold occurrence, comprising subvertical lodes defined by sulphide
disseminations and auriferous tourmaline-quartz veins and breccias. The
principal host rocks at Korvilansuo are volcanogenic metasediments which are
metamorphosed and altered to chloritic and sericitic schists under transitional
greenschist-amphibolite facies conditions and intruded by quartz-feldspar
porhyric tonalite dikes. Korvilansuo lies within the N-NE trending Korvilansuo
Shear Zone, near the southern end of the Korvilansuo-Kivisuo-Elinsuo-Muurinsuo
mineralized zone, subparallel with the contact of the Kuittila tonalite
intrusion, which also host gold mineralization. Native gold is irregularly
distributed through host rock disseminations and in quartz veins as inclusions
in biotite, pyrrhotite, pyrite and arsenopyrite, as free grains up to 1 mm in
size between silicates and intergrown with bismuth, tellurides and rutile.
Several hundred assays have been additionally checked with 0.5 kg screen fire
assay or 500 g cyanide leach procedures so that nugget effects may be clearly
distinguished.

Finnish authorities have within the last two weeks granted new claims covering
the whole target area for the next 5 years. Korvilansuo and the neighboring
areas have thus been covered by recently granted, already existing claims or new
claim applications.

The drilling database will as soon as possible be sent to Outotec Oyj for
resource estimation and the resource estimate will be published in due course.

RÄMEPURO
Four new exploration holes, totaling 320 m, were drilled at the Rämepuro
deposit. The following intersections were received from the assays:

Table included in attached PDF

The drilling database has been sent to Outotec Oyj for the resource estimation.

A metallurgical study on mineralized bulk sample taken at the surface of
Rämepuro gold deposit has been carried out in September 2012 at the Geological
Survey of Finland (GTK) for Endomines Oy. Among other tests, the feasibility of
adopting the present Pampalo Mill flow sheet for Rämepuro was tested by down
-scaling the flow sheet at the GTK pilot plant.

The metallurgical tests were carried out on 370 t mineralized samples from the
Rämepuro deposit. The head grade of the sample was 2.4 g/t gold. The total net
energy consumption for grinding in a two-stage ball mill circuit varied from 12
to 13 kWh/t, the latter when finer grinding was applied.

The average gold recovery in the tests was 86.5 % varying from 72.7 % to 92.7 %.
The mass percentage of the bulk concentrate (gravity+flotation) was 1.71 wt%.
The gold recovery of the shaking table concentrate varied between 30 and 45 %.
The average gravity concentrate had a gold grade of 3,502 g/t at a recovery of
38.5 % and the average silver grade was 1,362 g/t at a recovery of 20.3 %.

Samples for an environmental permit application were collected during the pilot
plant test run.

Drilling technical and QA/QC procedures
All drilling has been carried out by Pöyry Finland Oy, using WL-66 (~NQ2) tubes,
resulting in cores of 50.5 mm in diameter. The locations of the drill holes have
been surveyed using GNSS-GPS equipment. Azimuth and dip deviations have been
measured using the Reflex Maxibor Borehole Survey System.

The preparation and assaying of the half-core samples cut by Endomines have been
carried out at the Labtium laboratory in Rovaniemi. Finland. The sample
procedure used at the Labtium laboratory was Pb - Fire Assay of 50g subsample
and determination of gold using the ICPOES method (Labtium code 705P). Any assay
with gold grades exceeding 10 g/t was re-assayed using a 50g Fire Assay method
and gravimetric analysis (Labtium code 705G). Control assays have been done for
278 samples with 500 g Screen Fire assay or 500 g Cyanide leach (Labtium code
236A) methods to prevent the nugget effect.

Normal QA/QC (Quality Assurance/Quality Control) procedures have been adhered to
on all the samples, with standards blanks and duplicates routinely submitted as
part of the sampling program. The quality of sample preparation, security,
integrity and chemical assays was equal to, or exceeded current industrial
standards and the requirements of the JORC-code.

This statement has been prepared by Jaakko Liikanen (MSc Geol) acting as a
Qualified Person in compliance with SveMin-FinnMin rules. He owns 1,143,892
(1.44%) Endomines AB shares and is employed by the Company as Chief Technical
Officer. The data supporting this news release has been included in a Surpac
database and has been verified against the original laboratory assay
certificates.

For further information, please contact:
Markus Ekberg. CEO of Endomines AB
tel. +358 40 706 48 50
or visit the Company's website at
www.endomines.com

Endomines AB discloses the information provided herein pursuant to the Swedish
Securities Markets Act and/or the Swedish Financial Instruments Trading Act. The
information was submitted for publication at 09:00 CET on January 21, 2013.

About Endomines AB
Endomines AB is a Nordic mining and exploration company with its first operating
gold mine in production since February 2011. The mine is located in Eastern
Finland, on the Karelian Gold Line, a 40 km long gold critical belt, where
Endomines controls all currently known gold deposits.

The company has several other gold and industrial mineral properties at various
stages of development. All Endomines’ mineral assets are located in Finland,
which is politically stable, has a highly developed infrastructure and is ranked
as one of the most favorable jurisdictions for the mining industry.

Endomines aims to increase shareholder value by developing its strong portfolio
of assets, as well as exploring new deposits on the Karelian Gold Line and in
Finnish Lapland. The company will also consider new opportunities and
acquisitions for further growth.

The company’s business practices and mining operations are based on sustainable
principles and on minimizing the impact on the environment.

Endomines applies SveMin's&FinnMin's respective rules for reporting (public
mining & exploration companies). It has also chosen to report mineral resources
and ore reserves according to the JORC-code, which is the internationally
accepted Australasian code for reporting ore reserves and mineral resources.

The shares of Endomines AB are quoted on NASDAQ OMX Stockholm under ticker
ENDO.ST. Pareto Öhman acts as Liquidity Provider.

Read more about Endomines on www.endomines.com

This news release may contain forward-looking statements, which address future
events and conditions, which are subject to various risks and uncertainties. The
Company's   actual   results, programs and financial position could differ
materially from those anticipated in such forward-looking statements as a result
of numerous factors, some of which may be beyond the Company's control. These
factors include: the availability of funds; the timing and content of work
programs;   results   of exploration activities and development of mineral
properties, the interpretation of drilling results and other geological data,
the uncertainties of resource and reserve estimations, receipt and security of
mineral property titles; project cost overruns or unanticipated costs and
expenses, fluctuations in metal prices; currency fluctuations; and general
market and industry conditions.

Forward-looking statements are based on the expectations and opinions of the
Company's management on the date the statements are made. The assumptions used
in the preparation of such statements, although considered reasonable at the
time of preparation, may prove to be imprecise and, as such, undue reliance
should not be placed on forward-looking statements.

Tables included in attached PDF