The truck-mounted RC drill rig set up on drill hole RV21-007 on July 7, 2021. The locations of the four holes completed for the Phase II program are shown in Figure 1. This view is north; the drill is set up on the Kawich IP anomaly located in the covered valley, with the G1 target drilled in the first half of the program located behind the drill in this view, approximately 1km to the northeast on the lower flank of the ridge. The historic silver-copper workings shown on Figure 1 can be seen higher on the light-coloured ridge on the right side of this photo.
The truck-mounted RC drill rig set up on drill hole RV21-007 on July 7, 2021. The locations of the four holes completed for the Phase II program are shown in Figure 1. This view is north; the drill is set up on the Kawich IP anomaly located in the covered valley, with the G1 target drilled in the first half of the program located behind the drill in this view, approximately 1km to the northeast on the lower flank of the ridge. The historic silver-copper workings shown on Figure 1 can be seen higher on the light-coloured ridge on the right side of this photo.