Metanor Intersects 7.4 g/t Au over 4.4 metres at the Barry Project


VAL D'OR, Quebec, July 16, 2018 (GLOBE NEWSWIRE) -- Metanor Resources Inc. (the “Company” or "Metanor") (TSX-V:MTO) is pleased to announce drill results from the on-going drill campaign at the Barry project, including new high-grade results of 7.4 g/t Au over 4.4 metres, 7.1 g/t Au over 4.2 metres, 9.4 g/t Au over 2.9 metres and 8.2 g/t Au over 2.6 metres. These new drill holes were designed to expand the deposit westerly and at depth, which continues to demonstrate strong continuity to the mineralized system.

Highlights from new drillholes include:

• MB-18-195from 226.8 m. to 238.4 m.3.7 g/t Au over 11.6 m
 Including 226.8 m. to 231.2 m.7.4 g/t Au over  4.4 m.
   
 Sheared basalt zones with, quartz stockwork, 2% pyrite multiple VG grains.
   
• MB-18-191from 193.8 m. to 198.0 m.7.1 g/t Au over 4.2 m.
   
 Massive basalt with local shearing, quartz-carbonate stringers, chlorite-carbonate alteration and 1-2% pyrite.
   
MB-18-194from 151.4 m. to 154.0 m.8.2 g/t Au over 2.6 m.
   
 Basalt host with quartz stockwork, chlorite-carbonate-biotite-albite alteration and 1% pyrite.

Highlights of the last 10 drill holes that intersected multiple shears include:

Hole #From (m)To (m)Length (m)Grade Au (g/t)
MB-18-186156.8161.04.22.8
including156.8157.60.810.5
 213.6216.42.84.9
 239.1240.91.83.9
MB-18-187178.0179.71.79.8
 196.5197.10.63.3
MB-18-188145.5147.62.17.4
 293.5294.51.016.3
 305.6307.21.63.8
MB-18-189143.3144.31.03.0
 169.6171.51.94.2
 179.3180.31.03.0
 202.3206.84.52.2
 220.0220.60.65.7
 341.9344.02.13.8
MB-18-190232.0233.81.82.6
 370.5373.53.02.3
MB-18-191193.8198.04.27.1
 207.5210.42.99.4
 264.0265.61.63.1
 285.8287.92.15.0
MB-18-193336.8337.30.56.0
MB-18-194151.4154.02.78.2
 183.5186.53.04.3
 231.3231.90.67.4
MB-18-195215.5217.01.53.5
 226.8238.411.63.7
including226.8231.24.47.4
MB-18-196231.5232.61.15.9
 264.3264.80.57.1
 318.5321.53.02.6
*Stated lengths are core width as drilled, true widths vary and average between 70 and 95 percent of drilled widths.


Drillholes locations:

Hole #AzimuthDip (º)Length (m)UTM EastUTM NorthElevation (m)
MB-18-186330-633724433995425906399
MB-18-187330-674024436755426023402
MB-18-188330-536874439665426072395
MB-18-189330-623544434555425902400
MB-18-190280-654204436755426023402
MB-18-191330-473664434555425901400
MB-18-192307-813694435815426064407
MB-18-193330-574624434665425780396
MB-18-194330-684864438285426178397
MB-18-195359-634444434955425923400
MB-18-196330-535254439115426122395

The development of the Barry ramp is progressing on schedule with approximately 300 metres of advancement to date. The ramp will provide access to both underground drill bays and extraction of the bulk sample program in Q4 2018.

Quality Control and Reporting Protocols

Metanor estimates that the actual thicknesses of the mineralized intersections are between 70% and 95% of the core lengths. No capping grade is used at this stage.  The Company uses a rigorous QA-QC analytical program according to industry standards. The analytical results were done by pyroanalysis (A.A.) at the mine laboratory. Blanks, duplicates and certified reference standards are inserted into the sample stream to monitor laboratory performance.  The company QA-QC analytical verification program requires that a minimum of 5% of the samples be audited at an independent laboratory.  These audit assays were sent to ALS laboratory located in Val-d'Or, Quebec. The results of the audits are consistent with those obtained.

The Barry Project

The Barry project is located in the Urban-Barry camp, 110 km east from the city of Lebel-sur-Quévillon, and 110 km south of the Bachelor mill.  624,414 tonnes of ore grading 2.2 g/t Au for 43,970 ounces were extracted from three small pits between 2008 and 2010.  A drilling campaign is underway at the Barry property to increase mineral resources below the pits in multiple high-grade shear zones and to proceed with an underground bulk sample program. The gold mineralization at the Barry project is structurally controlled and is hosted in a sheared basalt containing quartz-carbonate-albite veins with pyrite. Metanor has identified three main sub-vertical shear zones and approximately ten secondary lower dipping tension veins. These structures are open in all directions.

Qualified Persons

Pascal Hamelin, P. Eng., President and COO, is the Qualified Person under NI 43-101, who is responsible for reviewing and approving the technical information contained in this news release.

Cautionary and Forward-Looking Statements

This press release includes certain statements that may be deemed as "forward-looking statements". The potential quantity and grade is conceptual in nature as there has been insufficient exploration to define a mineral resource and it is uncertain if further exploration will result in the target being delineated as a mineral resource.  All statements in this discussion, other than those of historical fact, that address future exploration drilling, exploration activities and projected exploration, including costs and other estimates upon which such projections are based, and events or developments that the company expects, are considered forward-looking statements.  Although the Company believes the expectations expressed in these forward-looking statements are based on reasonable assumptions, such statements are not guarantees of future performance and actual results or developments may differ materially from those forward-looking statements.

Neither the TSX Venture Exchange, nor its Regulation Services Provider accepts responsibility for the adequacy or accuracy of this release.

For more information, please contact:
Pascal Hamelin, President & COO
Telephone: 819-825-8678
email: phamelin@metanor.ca
2872, Sullivan Rd, suite 2
Val-d'Or, QC J9P 0B9

Two maps accompanying this announcement are available at

http://www.globenewswire.com/NewsRoom/AttachmentNg/b1cbc7d2-0906-4b86-aaac-c463d5a6f622

http://www.globenewswire.com/NewsRoom/AttachmentNg/cc633588-51ea-40ed-81ff-9dbc0e1f8c3d

Plan view of the Barry Project: Section A to A`